Advanced settings
Functions available on top of Basic settings described in previous chapter.
Network
The device network can be set to either DHCP or a static IP address.
Network
DHCP:
Enable DHCP (Dynamic Host Configuration Protocol) to dynamically distributing network configuration parameters;
IP:
Configure Static IP address to manually distributing network configuration parameters;
Mask:
Subnet mask;
Gateway:
A component that is part of two networks, which use different protocols;
DNS:
Domain Name Server of the device;
Room
The Device number can be from 0 to 9. But you must have one Indoor Monitor’s Device number is 0 and keep it online because 0 here stands for the main one. Or go to Indoor Monitor’s webpage and find Ex Phone in Intercom > Call. Users can directly extend to more Indoor Monitors by filling in sip:[IP address] (6 Max) such as sip:192.168.68.90. (Please refer to WEB SETTING for the way to access to webpage).
Room
Register To Cloud:
Configures the device to register to the cloud server. Valid values: Enable/Disable;
Automatic deployment:
Configures whether the device is allowed to automatically connect to the cloud platform and obtain configuration. Valid values: Enable/Disable.
Auto-enabled when device registered via Cloud Platform – all below mentioned parameters are read only then;
Site ID:
Configures the device to automatically connect to the specified site of the cloud platform (max 10 characters)
Building:
Number of the building (Range: 1-999);
Unit:
Number of the unit (Range: 0-99);
Apartment No.:
Number of the apartment (Range: 0-9899);
Device No.:
Number of the device (Range: 0-9);
Sync:
A number used to synchronize to other Indoor Monitors;
SIP
Account 1
Status (via cloud service):
Shows the device status registration with SIP server;
Account 2
SIP:
Enable to use SIP;
Display Name:
Display name of SIP account;
Register Name:
Register Name of SIP account;
Username:
Username of SIP account;
Password:
Password of SIP account;
SIP Server Host:
Directly fill in SIP server’s address e.g., 192.168.68.90;
The default port is 5060;
Outbound Proxy:
Outbound Proxy server; the default port is 5060;
Registration Duration:
Registration duration when the device registers with the SIP server; (sec)
Transport Protocol:
Transport Protocol (UDP, TCP, TLS);
Video Payload:
Video payload range is 96-127;
DNS SRV:
Enables the DNS SRV function when the device registers with the SIP server;
Other
Ring Code:
Selects the SIP response type used to signal an incoming call.
180 (default), 183 – depending on the SIP server or indoor monitor compatibility
Video Payload:
Specifies the RTP payload type number used to identify the video codec stream during a SIP call (96 – 127)
Password
Password
Old Password:
Current administrator password of the Device (Default 123456);
New Password:
New administrator password of the Device;
Confirm Password:
Confirm administrator password of the Device;
Apps
Shows the available functions of the Android system.
Reset
Reset
Reset:
Reset to factory default;
Last updated