For the complete documentation index, see llms.txt. This page is also available as Markdown.

Mounting & Installation

I. Choose the suitable height of camera and put the label sticker on the wall.

II. According to the sticker, drill three 8 x 45mm for screws and one 5mm for wire outlet.

III. Insert 3 screw fixing seats into the screw holes.

IV. Remove the sticker after drilling.

V. Lock the rain hood or rear cover with 3 screws

VI. Let wires(included) and network cable without RJ-45 plug go through rear cover and waterproof seal plug.

VII. Connect RJ-45 Plug.

VIII. Plug waterproof seal plug into the cover groove at the bottom.

IX. Fix interface clamp to the device with 2 screws.

X. Hang up device with rear cover.

XI. Use wrench to lock the bottom of the device with 1 screw (different screws for rain hood and rear cover).

Last updated