Buttons page

Buttons

In this section, you can configure the functions of individual buttons on the RFTC-3 device. Each button can be assigned a specific function based on your needs.

Configuration Options

• Opening the Buttons Tab: In the Buttons tab, you can set the individual functions of the RFTC-3 buttons.

• Button Settings: After opening the settings, a display preview with virtual buttons will appear. You can click on these buttons to open a menu where you can set the function of each button.

• Default Settings: If you do not wish to change the buttons, it's not necessary. You can leave the buttons in their default configuration.

• Available Settings: When configuring a button, you can choose from the following modes:

  • Function: Contains all basic functions, such as:

    • Up Temperature / Down Temperature – to increase or decrease the temperature

    • Mode – to switch between Heat and Cool modes

    • DND – Do Not Disturb mode

    • MUR – a specific function for certain models

    • Temp – to change the temperature unit between Celsius and Fahrenheit

    • Fan – to control fan speed

    • Reg – for turning regulation on/off or switching modes

    • None – unassigned button

  • Automation: You can assign a button to trigger automation in the system.

  • RF Button: You can assign buttons with IDs 1–8 for two addresses (1–2).

• RF Button Pairing: If you select RF Button, you can pair the button with an RF actuator by initiating the pairing mode. Press the Pair button to activate pairing mode.